New Structures · Government
Block Panchayat Office Building
Parassala, Thiruvananthapuram
- Type
- Government office
- System
- RCC frame + roof truss
- Software
- ETABS, AutoCAD
The project
A block panchayat office building at Parassala, Thiruvananthapuram, framed in RCC with a roof truss. The design was prepared with reference to the original scanned drawings and the existing column and beam layout on site.
Our approach
- Traced the existing column and beam layout and the original drawings into a clean structural layout
- Modelled the building in ETABS with floor loads, the overhead water-tank load and IS 1893 seismic loads
- Designed footings, columns, plinth beams and floor beams, and the roof truss
- Prepared plinth beam, ground- and first-floor column, and first- and second-floor beam layouts
Outcome
Footing, column and beam drawings with calculation sheets for every member type, issued for construction.
The structure in numbers
The ETABS model of this structure has 4 levels and rises 13.2 m over a footprint of about 30 × 11 m. It contains 89 columns and 156 beams, each checked and designed in the model. Members are designed in M20 and M25 concrete with Fe 415 reinforcement to IS 456: 2000. A modal analysis was run to check how the building sways and vibrates before the members were finalised.
Structural system
- Concrete
- M20, M25
- Reinforcement
- Fe 415
- Typical columns
- 300 × 400 mm
- Typical beams
- 250 × 350 mm · 250 × 450 mm
- Slabs
- 120, 130 mm thick
- Floor loads
- Water tank: 10 + 0.75 kN/m² · Floors: 2 + 3 kN/m²
- Seismic design
- IS 1893 (Part 1), zone III, soil type II, special moment-resisting frame
- Analysis
- 3D ETABS model — linear static analysis
- Foundation
- Isolated footings
Site photos





